Floor Grinding And Polishing Machine Floor Grinding And Polishing Machine,Ronlon Machinery,Concrete Floor Grinding Machine Hose Crimping Machine Co., Ltd. , http://www.hf-pipefitting.com
Features:
1.adjust the blade by computer,no gasket
2. The back end can be semi-stripped
3. Operation screen KINCO7 inch full english version
4.Pneumatic parts is TAIWAN Airtac
5. Control: 32 full SCM control system
6. Servo: Delta servo
7. Guide rail with silver, decelerator PHT
8. Detection of Japanese keenshi. Omron
9. The rear end is suitable for horizontal, straight OTP mould
Product specifications:
1.Model: high speed automatic terminal press (double end pressing)
2.Machine function: the computer controls both ends of the pressure, blade, peeling, semi-stripping and detection
3.Production capacity: 0.7sec/bar at both ends of the length 40MM
4.Speed: 40MM an hour 4000 root (feed speed 3000secMAX)
5.Wire cut length: 40-9999mm
6.Cut off accuracy: the deviation is 0.5MM when the cutting length is less than 100MM, and the cutting length is greater than 100MM and the deviation is positive and negative 1.0MM
7.Stripping length: 1 side 0.1-9.0 (semi-stripping 3.0-9.0 MM) 2 side 1.0-9.0MM (half stripping length 3.0-9.0 MM)
8.Press ability: 19600N(2T) mute terminal machine 2 (using mould AS42.AS40.AAE30)
9.Control mode: 32-bit microcomputer system
10.Check  function: check whether there are any wires, check the wire too tight, detect abnormal pressure, check the abnormal
11.Power supply: single phase AC220 50/60hz
12.Compressed air: 0.4mpa - 0.5mpa (with air volume about 130NI/min- 180NI/min)
13.Temperature range: around 15-30 degrees
14.Machine size: 1000*700*1550MM (not including the protrusions)
15.Weight: 460KG
Â