Circular Saws, Portable Circular Saw, Electric Circular Saw, Metal Circular Saw NINGBO LUBAN ELECTRIC POWER TOOLS CO.,LTD. , https://www.aye-group.com
There are two methods for sticking and floating in carpets. Sticking is to stick the perimeter of the carpet to the ground with double-sided tape; the float is to lay the carpet on the floor and not stick around.
When carpeting is used, the specific size and shape of the room floor should be carefully measured. The net length and net width of the room floor should be measured along the bottom edge of the skirting board. If the two net length values ​​or the two net width values ​​are different, the larger value should be taken. If there is a door or an empty circle in the room, it should be measured at the bottom of the door or at the outer edge of the empty circle. Because the carpet at the entrance or empty circle is connected with the carpet in the room, and the score is not scored, the net length or width of the ground in the room should be counted at the entrance or empty circle.
When purchasing a carpet, the required length of the carpet is equal to the net length of the room plus the cutting loss rate, and the cutting loss rate is about 0.5% to 1% of the length of the carpet. The width of the carpet is preferably equal to the net width of the room, so that the entire paving is complete and saves material. It is also possible that the width of the carpet is slightly greater than the net width of the room, so that a little cut can be made and the waste is not much. If the room is wide, try to make a half-patch, or a few full-size carpets, leaving the entire carpet unremarkable.
Before laying carpets, clean the floor and do not get wet. Spread the carpet flat on the ground and cut it according to the net length of the room and the dimensions of the doorway and the empty circle. The trimming edge strives to be straight and tidy.
For sticky carpets, the adhesive tape line should be drawn on the ground first. According to this range, double-sided adhesive tapes should be spread on the ground. Then stick one end of the broadside of the carpet to the double-sided adhesive tape, slowly spread the carpet, and spread the long side of the carpet on the double-sided adhesive tape until the other end of the carpet is glued to the double-sided adhesive tape. .
Floating carpets should be laid flat on the ground with a wide edge of the carpet and pressed with a heavy wood board. The carpet is then unfolded slowly and flattened until the other side of the carpet is wide.
Partial carpets are generally floated, and large ones can be adhered.
If there is a piece of carpet in the carpet, the seams should be arranged so that the edges of the carpet are tightly aligned and do not overlap. There should not be a long seam in the room.
The cut edge of the non-full carpet should be at the base of the wall.
If the carpet is straight or inverted, it should be noted that the carpet's hair should be in one direction.
If the carpet has a positive or inverted pattern, the pattern on the carpet should be visible at the entrance to the door, especially the scenery, animals and plants. Pay special attention to the door. If there is a patterned rug that requires a piece of fabric, the pattern must be completed after the pieces are mixed.
In the doorway or hollow area, the carpet shall be pressed with an aluminum alloy strip or copper strip, and the strip shall be fixed on the ground.
How to lay a carpet?
There are two methods for laying the carpets in the room: full and partial. The shop is full of carpets on the floor of the room; the local shop is carpeted on the floor of the room, and the carpet is not covered under the furniture.